Yamaha 2010 XVS1100Z Owner's Manual page 24

INSTRUMENT AND CONTROL FUNCTIONS
Engine trouble warning light "
This warning light comes on or flashes
if a problem is detected in the electrical
circuit monitoring the engine. If this oc-
curs, have a Yamaha dealer check the
self-diagnosis system. (See page 4-6
for an explanation of the self-diagnosis
device.)
The electrical circuit of the warning light
can be checked by turning the key to
4
"ON". The warning light should come
on for a few seconds, and then go off.
If the warning light does not come on
initially when the key is turned to "ON",
or if the warning light remains on, have
a Yamaha dealer check the electrical
circuit.
Immobilizer system indicator light
(XVS1100AZ)
The electrical circuit of the indicator
light can be checked by turning the key
to "ON". The indicator light should
come on for a few seconds, and then
go off.
EAU11505 If the indicator light does not come on
"
initially when the key is turned to "ON",
or if the indicator light remains on, have
a Yamaha dealer check the electrical
circuit.
When the key is turned to "OFF" and 30
seconds have passed, the indicator
light will start flashing indicating the im-
mobilizer system is enabled. After 24
hours have passed, the indicator light
will stop flashing, however the immobi-
lizer system is still enabled.
TIP
This model is also equipped with a self-
diagnosis device for the immobilizer
system. If the immobilizer system is not
working correctly, the indicator light will
start flashing a pattern when the key is
EAU38913 turned to "ON". When this occurs, have
a Yamaha dealer check the self-diag-
nosis system. However, if the indicator
light slowly flashes five times, and then
quickly flashes two times repeatedly,
this error could be caused by signal in-
terference. If this occurs, try the follow-
ing.
1. Use the code re-registering key to
start the engine.
TIP
Make sure there are no other immobi-
lizer keys close to the main switch, and
do not keep more than one immobilizer
key on the same key ring! Immobilizer
system keys may cause signal interfer-
ence, which may prevent the engine
from starting.
2. If the engine starts, turn it off, and
3. If one or both of the standard keys
4-5
try starting the engine with the
standard keys.
do not start the engine, take the
vehicle, the code re-registering
key and both standard keys to a
Yamaha dealer and have the stan-
dard keys re-registered.