Yamaha 2010 XVS1100Z Owner's Manual page 37

XVS1100AZ
1
2
1. Quick fastener
2. Mudguard
5. To increase the spring preload and
thereby harden the suspension,
turn the adjusting ring in direction
(a). To decrease the spring pre-
load and thereby soften the sus-
pension, turn the adjusting ring in
direction (b).
G
Align the appropriate notch in
the adjusting ring with the po-
sition indicator on the shock
absorber.
G
Use the special wrench in-
cluded in the owner's tool kit
to make the adjustment.
INSTRUMENT AND CONTROL FUNCTIONS
XVS1100Z
1. Spring preload adjusting ring
2. Position indicator
3. Special wrench
XVS1100AZ
1. Position indicator
2. Spring preload adjusting ring
3. Special wrench
4-18
Spring preload setting:
Minimum (soft):
1
Standard:
3 (XVS1100Z)
4 (XVS1100AZ)
Maximum (hard):
7 (XVS1100Z)
9 (XVS1100AZ)
6. Install the mudguard and ignitor
unit panel by installing the quick
fasteners.
7. Install the rider seat.
WARNING
This shock absorber assembly con-
tains highly pressurized nitrogen
gas. Read and understand the fol-
lowing information before handling
the shock absorber assembly.
G Do not tamper with or attempt to
open the cylinder assembly.
G
Do not subject the shock ab-
sorber assembly to an open
flame or other high heat source.
This may cause the unit to ex-
plode due to excessive gas
pressure.
4
EWA10221