Toyota 2012 Highlander Owner's Manual page 422

■
Reset the maintenance data (U.S.A. only)
After the required maintenance is performed according to the maintenance
schedule, please reset the maintenance data.
To reset the data, follow the procedures described below:
Vehicles without smart key system
STEP 1
Set the engine switch to the "LOCK" position with the trip meter A
reading shown. (→P. 185)
STEP 2
While pressing the trip meter reset button, set the engine switch to
the "ON" position.
Vehicles with smart key system
STEP 1
Set the "ENGINE START STOP" switch OFF with the trip meter A
reading shown. (→P. 185)
STEP 2
While pressing the trip meter reset button, set the "ENGINE START
STOP" switch to the IGNITION ON mode.
STEP 3
Without multi-information display: Continue to press and hold the
button until the trip meter displays "000000".
With multi-information display: Continue to press and hold the but-
ton until "COMPLETE" appears on the multi-information display.
■
Allow inspection and repairs to be performed by a Toyota dealer
●
Toyota technicians are well-trained specialists and are kept up to date
with the latest service information. They are well informed about the
operations of all systems on your vehicle.
●
Keep a copy of the repair order. It proves that the maintenance that has
been performed is under warranty coverage. If any problem should arise
while your vehicle is under warranty, your Toyota dealer will promptly
take care of it.
4-2. Maintenance
447
4