Indicators And Projector Condition - Sanyo plc-xu4001 Owner's Manual

at start-up.
not work.
If problems still persist after following all operating instructions, contact the dealer where you
purchased the projector or the service center. Specify the model number and explain about the
problem. We will advise you how to obtain service.
The CE Mark is a Directive conformity
mark of the European Community (EC).
Pixelworks ICs used.
Licensed under USP5,717,422 USP6,816,141
– Check PC adjust menu or Screen menu and adjust them.
See pages 29-30, 34-35.
– PIN code lock is being set. Enter a PIN code (the "1234"
or number you have set). See pages 19, 55-56.
– Check the batteries.
– Make sure no obstruction is between the projector and
remot controller.
– Make sure you are not too far from the projector when
using the remote control. Maximum operating range
is 16.4'(5 m).
– Make sure the code of the remote control is conformed to
the projector's code. See page 54.
– Unlock the Key lock function for the remote control function.
See page 55.
– Check the status of the projector with referring to
"Indicators and projector Condition". See page 70.
– Your operation is invalid. Operate correctly.
– The top control is not available if the top control is locked at
under
– Contact the dealer where you purchased the projector or
the service center.
of Setting section. See page 55.
This symbol on the nameplate
means the product is Listed
by Underwriters Laboratories
Inc. It is designed and
manufactured to meet rigid U.L.
safety standards against risk
of fire, casualty and electrical
hazards.
67