Indicators And Projector Condition - Sanyo PLC-ET40L Owner's Manual

Appendix

Indicators and Projector Condition

Check the indicators for the projector condition.
WARNING TEMP . indicator
Indicators
POWER LAMP
green
POWER, LAMP , WARNING
TEMP ., WARNING FILTER,
and LAMP REPLACE
indicators are blinking all
together.
• • • lighting
68
WARNING
TEMP .
red
red
The projector is off. (The AC power cord is unplugged.)
The projector is in stand-by mode. Press the ON/STAND-BY button to
turn on the projector.
The projector is operating normally.
The projector is in the Power management mode.
The projector is preparing for stand-by or the projection lamp is
being cooled down. The projector cannot be turned on until cooling is
completed and the POWER indicator stops blinking.
The WARNING TEMP . indicator blinks slow when the temperature
inside the projector is elevated close to the abnormally high level.
The temperature inside the projector is abnormally high. The
projector cannot be turned on. When the projector is cooled down
enough and the temperature returns to normal, the POWER indicator
stops blinking and the projector can be turned on. (The WARNING
TEMP . indicator keeps blinking.) Check and clean the filter.
The projector has been cooled down enough and the temperature
returns to normal. When turning on the projector, the WARNING
TEMP . indicator stops blinking. Check and clean the filter.
The projector detects an abnormal condition and cannot be turned
on. Unplug the AC power cord and plug it again to turn on the
projector. If the projector is turned off again, unplug the AC power
cord and contact the dealer or the service center. Do not leave the
projector on. It may cause an electric shock or a fire hazard.
• • • blinking
Projector Condition
• • • off