Plumbing - Miele G 7835 CD Installation And Operating Instructions Manual

Water inlet
,
Water in the machine is not
suitable for drinking.
^ The machine must be connected to
the water supply in accordance with
local and national regulations.
^ The washer-disinfector is constructed
so it may be connected to a supply
without an extra non-return valve,
unless required by code.
^ Water supply pressure
Hot + Cold water connection =
min. 12 psi - max.145 psi
DI water connection =
min. 9 psi - max. 145 psi
^ Recommended water pressure
Hot + Cold water connection =
over 37 psi - max.145 psi
DI water connection =
over 22 psi - max. 145 psi
to avoid long intake times
^ If the water pressure is not in the
range of 12 to 145 psi, contact
Miele's Technical Support. The
display might show "CHECK WATER
INTAKE".
^ The machine is supplied standard to
be connected to a cold (coded blue)
and a hot (coded red) water supply
to a maximum temperature of 158 °F
(70 °C).
Connect the water intake hoses to the
cold and hot water faucets. The
steam condenser inlet hose (without
waterproof connector) should be
connected to the cold water supply,
using the adapter supplied.
If no hot water supply is available,
the hot water inlet hose marked red
should also be connected to a cold
water supply by a y-adapter.
For a DI-water connection (H2O
pure), see next page.
^ Water valves with
hose thread are to be provided on
site. They should be easily
accessible so the water supply can
be turned off if necessary.
^ The inlet hoses are 5 ½ feet (1.7 m)
long, terminating in a
female hose thread. The water inlet
filters in the threads must not be
removed.
^ Large surface area filters are
enclosed in the kit supplied with the
machine.
Install these filters between the water
valve and the water inlet hose (see
illustration in "Cleaning the water inlet
filters"). The large surface area filter
for DI water is made from stainless
steel and can be recognized by its
matte surface.

Plumbing

3
/ " (2 cm) male
4
3
/ " (2 cm)
4
59