Setting The Water Softener; Salt Indicator; Filling The Salt Reservoir - Miele G 7835 CD Installation And Operating Instructions Manual

Water softener

Setting the water softener

Before using the machine for the first
time, the programming must be set to
the local water hardness(see
"Programming manual", "Operating
information / Regeneration").

Salt indicator

If the display shows NO SALT, the salt
reservoir needs to be filled.
The water softener is automatically
regenerated while the next program is
running.
The program display will show
REACTIVATION during this process.
16

Filling the salt reservoir

Only special, coarse-grained
reactivation salt*, with a grain size of
1-4 mm, should be used in this
machine.
*Available from your Miele dealer.
Do not use other types of salt, e.g. table
salt, agricultural or de-icing salt. These
could contain components which are
insoluble in water and could damage
the water softener. If in doubt, consult
Miele Technical Service.
The salt reservoir holds approximately
2.5 kg salt.
,
Inadvertently filling the salt
reservoir with detergent WILL
damage the water softener.
Before filling the reservoir, always
make sure that you are using
reactivation salt.
^ Remove the bottom basket from the
machine.
^ Unscrew the salt reservoir cap.
Before filling the salt reservoir for the
first time fill the reservoir with
approximately 2.5 liters of water, so
that the salt can dissolve properly.
Once the washer-disinfector has
been operated, there will always be
enough water in the reservoir.