Water Softener; Setting The Water Softener - Miele G 7893 Operating And Installation Instructions

Water softener

Before using the machine for the first
time, the water softener should be
programmed. The water needs to be
softened to avoid calcium deposits on
the items being cleaned and in the
machine itself.
If the water supply is harder or softer
than the factory setting (including
below 4 gr/gal or 70 ppm), the setting
will need to be changed. See "Setting
the water softener".
– In order to function properly, the
water softener requires a supply of
reactivation salt.
– The cleaner must be correctly
programmed to match the hardness
of the tap water supply.
– Your local water authority can
provide information about the
hardness of the tap water in your
area.
If the water hardness is known to
fluctuate, always program for the
highest value.
The built-in water softener can be
programmed at settings from
1 - 60 gr/gal or 20 - 1080 ppm.
It is useful to make a note of your water
hardness so that you can provide the
service technician with this information
in the event of any service calls.
Please note the water hardness in the
space provided here:
12
gr/gal or ppm

Setting the water softener

^ Use the On/Off button to switch off
the machine.
^ Turn the program selector to f.
^ Simultaneously press and hold the
"Display" ß and "Start" 6 buttons,
while turning the machine on with the
On/Off button.
The current program status P....
will appear in the display, and the
"Fill/Drain" indicator will come on.
^ Press the "Drying" 0 button once.
E01 will appear in the display.
^ Turn the program selector one switch
position clockwise (to 1 o'clock).
The number 19 will appear in the
display (this indicates the factory
setting in gr/gal).
^ Press and hold the "Display" ß
button until the required value
appears in the display.
Please refer to the "Settings" table for
detailed water hardness tables (water
hardness in gr/gal and ppm).
Once the 60 setting has been reached,
the counter begins again from 0.
^ Press "Start" 6.
SP will appear in the display.
^ Press "Start" 6 again.
The setting you selected will now be
stored in memory. The display light(s)
will turn off.
The machine is now ready for use.