Combination Switch - Mercedes-Benz B-Class Electric Drive Operator's Manual

Exterior lighting
102

Combination switch

Turn signal
High-beam headlamps
:
Turn signal, right
;
High-beam flasher
=
Turn signal, left
?
To indicate briefly: press the combination
X
switch briefly to the pressure point in the
direction of arrow ; or ?.
The corresponding turn signal flashes three
times.
To indicate: press the combination switch
X
beyond the pressure point in the direction
of arrow ; or ?.
High-beam headlamps
To switch on the high-beam headlamps:
X
turn the SmartKey in the ignition lock to
position 2 or start the drive system.
Turn the light switch to L or Ã.
X
Press the combination switch beyond the
X
pressure point in the direction of arrow :.
In the à position, the high-beam head-
lamps are only switched on when it is dark
and the engine is running.
The blue K indicator lamp in the instru-
ment cluster lights up when the high-beam
headlamps are switched on.
To switch off the high-beam head-
X
lamps: move the combination switch back
to its normal position.
The blue K indicator lamp in the instru-
ment cluster goes out.
High-beam flasher
To switch on: turn the SmartKey in the
X
ignition lock to position 1 or 2 or start the
drive system.
Pull the combination switch in the direction
X
of arrow =.
Hazard warning lamps
To switch on the hazard warning lamps:
X
press button :.
All turn signals flash. If you now switch on a
turn signal using the combination switch,
only the turn signal lamp on the corre-
sponding side of the vehicle will flash.
To switch off the hazard warning lamps:
X
press button :.
The hazard warning lamps automatically
switch on if:
an air bag is deployed or
R
the vehicle decelerates rapidly from a
R
speed of above 45 mph (70 km/h) and
comes to a standstill
The hazard warning lamps switch off auto-
matically if the vehicle reaches a speed of
above 6 mph (10 km/h) again after a full
brake application.
The hazard warning lamps still operate if the
ignition is switched off.