Resetting - Mercedes-Benz B-Class Electric Drive Operator's Manual

handle on the driver's door. The SmartKey
must be close to the driver's door handle.
i
Vehicles with KEYLESS-GO or the KEY-
LESS-GO start function: the SmartKey
must be in close proximity to the vehicle.
Press and hold the & button until the
X
side windows are fully closed.
To interrupt convenience closing:
X
release the & button.
Using KEYLESS-GO
The driver's door and the door at which the
handle is used, must both be closed. The
SmartKey must be outside the vehicle. The
gap between the SmartKey and the corre-
sponding door handle should not be greater
than 3 ft (1 m).
Touch recessed sensor surface : on the
X
door handle until the side windows are fully
closed.
i
Make sure you only touch recessed sen-
sor surface :.
Make sure that all the side windows are
X
closed.
To interrupt convenience closing:
X
release recessed sensor surface : on the
door handle.
Resetting the side windows
If a side window can no longer be closed fully,
you must reset it.
Side windows
Close all the doors.
X
Turn the SmartKey to position 1 or 2 in the
X
ignition lock ( page 131).
Y
Pull the corresponding switch on the door
X
control panel until the side window is com-
pletely closed ( page 83).
Y
Hold the switch for an additional second.
X
If the side window opens again slightly:
Immediately pull the corresponding switch
X
on the door control panel until the side win-
dow is completely closed (
Hold the switch for an additional second.
X
If the respective side window remains
X
closed after the button is released, then it
has been set correctly. If this is not the
case, repeat the steps above again.
85
page 83).
Y
Z