Checking The Tire Pressure Elec Tronically - Mercedes-Benz B-Class Electric Drive Operator's Manual

Checking the tire pressure electroni-
cally
Make sure that the SmartKey is in position
X
2 in the ignition lock (
Y
Press = or ; on the steering wheel
X
to select the Serv.menu.
Press the 9 or : button to select
X
Tire Pressure.
Press the a button.
X
The current tire pressure of each tire is
shown in the multifunction display.
If the vehicle was parked for longer than
20 minutes, the Tire pressure will be
displayed after driving a few
minutes message is shown.
After a teach-in process, the tire pressure
monitor automatically detects new wheels or
new sensors. As long as a clear allocation of
the tire pressure value to the individual
wheels is not possible, the
Monitor Active message is shown instead
of the tire pressure display. The tire pressures
are already being monitored.
Tire pressure monitor warning mes-
sages
If the tire pressure monitor detects a pressure
loss in one or more tires, a warning message
is shown in the multifunction display. The yel-
low tire pressure warning lamp then lights up.
If the Please Correct Tire Pressure
R
message appears in the multifunction dis-
play, the tire pressure in at least one tire is
too low. The tire pressure must be correc-
ted when the opportunity arises.
If the Check Tire Pressure
R
appears in the multifunction display, the
tire pressure in one or more tires has drop-
ped significantly. The tires must be
checked.
If the Tire Pressure Warning Tire
R
Failure message appears in the multi-
function display, the tire pressure in one or
more tires has dropped suddenly. The tires
must be checked.
Observe the instructions and safety notes in
the display messages in the "Tires" section
( page 223).
Y
If the wheel positions on the vehicle are rota-
page 131).
ted, the tire pressures may be displayed for
the wrong positions for a short time. This is
rectified after a few minutes of driving, and
the tire pressures are displayed for the cor-
rect positions.
Restarting the tire pressure monitor
When you restart the tire pressure monitor, all
existing warning messages are deleted and
the warning lamps go out. The monitor uses
the currently set tire pressures as the refer-
ence values for monitoring. In most cases, the
tire pressure monitor will automatically
detect the new reference values after you
have changed the tire pressure. However, you
can also define reference values manually as
Tire Pressure
described here. The tire pressure monitor
then monitors the new tire pressure values.
Set the tire pressure to the value recom-
X
mended for the corresponding driving sit-
uation on the Tire and Loading Information
placard on the driver's side
B-pillar (
Additional tire pressure for various operat-
ing conditions can be found in the tire pres-
sure table in the charge socket flap
(
Y
Make sure that the tire pressure is correct
X
on all four wheels.
Make sure that the SmartKey is in position
X
2 in the ignition lock (
Press = or ; on the steering wheel
X
to select the
message
Press the 9 or : button to select
X
Tire
Press the a button.
X
The multifunction display shows the cur-
rent tire pressure for each tire or the
Tire pressure
page 305).
Y
page 148).
page 131).
Y
Serv. menu.
Pressure.
311
Tire
Z