List Of Error Codes - Panasonic CF-T2 Series Reference Manual

List of Error Codes

When turning on the computer, if one of the following error codes or messages is displayed,
follow the instructions shown below.
If the problem persists, or if the error code or message displayed is not shown here, contact
your technical support office.
Error Code/Message
0212: Keyboard error
0251: System CMOS checksum
bad - Default configuration used
0271: Check date and time
settings
0280: Previous boot incomplete -
Default configuration used
02B0: Diskette drive A error
Press <F1> to resume, <F2> to
Setup
Action
If an external keyboard is connected, disconnect this
device.
An error has occurred in the memory that stores the
Setup Utility settings. This error occurs when the
memory content is changed through some inadvertent
operation by a program or other function.
Run the Setup Utility and load the default values,
then change the settings to the appropriate values as
needed. ( page 79)
If the problem persists, the internal clock battery may
need to be replaced. Contact your technical support
office.
The date and time setting are incorrect.
Run the Setup Utility and set the date and time
correctly. ( page 82)
If the problem persists, the internal clock battery may
need to be replaced. Contact your technical support
office.
Startup has failed repeatedly, so the Setup Utility
settings have been returned to their default values, and
the computer has been booted.
Run the Setup Utility and load the default values,
then change the settings to the appropriate values as
needed. ( page 79)
Disconnect the floppy disk drive and reconnect it.
Make sure the drive is secured correctly.
Write down the error details and press F2 to run the
Setup Utility. Confirm the settings, and change the
settings to the appropriate values as needed.
( page 79)
91