Panasonic CF-T2 Series Reference Manual page 33

Security Measures
Starting Up When the Password on boot is Set
When you do not want the data on the hard disk to be read/
written
4
Select [Enable] or [Disable].
To enable the Password on boot
Select [Enable] and press Enter.
To disable the Password on boot
Select [Disable] and press Enter.
5
F10
Press and select [Yes], then press
The screen shown at left is displayed.
*1 and press Enter.
Enter your password
When the correct password is input, the computer will start.
When three incorrect password attempts or nothing is input for one minute, the computer
will power off.
*1
Supervisor Password or User Password set in the Setup Utility (not the Windows password).
When the Hard Disk Lock is set to [Enable], it is impossible to read/write data from/to the
hard disk when the hard disk is inserted in a different computer, since a password is also set
for the hard disk. When the hard disk is returned to the original computer, you can read and
write data as before. In this case, however, make the settings in the Setup Utility exactly the
same as they were before the hard disk was removed.
It is possible to set the Hard Disk Lock even if [Password on boot] is set to [Disable], but we
recommend that [Password on boot] be set to [Enable] for security reasons.
(Note that this Hard Disk Lock does not guarantee complete protection of data.)
NOTE
In the default setting, [Hard Disk Lock] is set to [Disable].
You cannot set [Hard Disk Lock] without setting the Supervisor Password. Set the
Supervisor Password if you have not done so. (
33
Enter
.
page 29)