List Of Error Codes - Panasonic CF-73 Series Reference Manual

List of Error Codes

When turning on the computer, if one of the following error codes or messages is displayed,
follow the instructions shown below.
If the problem persists, or if the error code or message displayed is not shown here, contact
Panasonic Technical Support.
Error Code/Message
Invalid system disk.
Replace the disk, and then press
any key
0200: Failure Fixed Disk
0211: Keyboard error
0251: System CMOS checksum
bad - Default configuration used
0271: Check date and time
settings
0280: Previous boot incomplete -
Default configuration used
Action
If a floppy disk is set inside the floppy disk drive when
it is connected to the USB port, remove the disk and
press any key.
Disconnect any device connected to the USB port
other than the floppy disk drive.
Disconnect the hard disk drive and reconnect it
again. Make sure the drive is secured correctly.
If an external keyboard is connected, disconnect this
device.
An error has occurred in the memory that stores the
Setup Utility settings. This error occurs when the
memory content is changed through some inadvertent
operation by a program or other function.
Run the Setup Utility and load the default values,
then change the settings to the appropriate values as
needed. ( page 76)
If the problem persists, the internal clock battery may
need to be replaced. Contact Panasonic Technical
Support.
The data and time setting are incorrect.
Run the Setup Utility and set the date and time
correctly. ( page 79)
If the problem persists, the internal clock battery may
need to be replaced. Contact Panasonic Technical
Support.
Startup has failed repeatedly, so the Setup Utility
settings have been returned to their default values, and
the computer has been restarted.
Run the Setup Utility and load the default values,
then change the settings to the appropriate values as
needed. ( page 76)
88