Panasonic CF-T2 Series Reference Manual page 103

Dealing with Problems (Advanced)
Disk Operations
Unable to read/write to the hard disk
Touch Pad
The cursor cannot be controlled
properly
Unable to input using the touch pad
Touchscreen
Unable to point correctly with the
stylus included with the computer
Unable to input by touching the display
Sound
The sound is not heard
Volume does not change when
Fn+F5 or Fn+F6 is pressed
The audio is distorted
Your drive or file may not have been properly set.
Check to see if the hard disk is full. If it is full, delete unnecessary files.
Your hard disk content may be corrupted. Contact your technical support
office.
If you are using an external mouse, ensure that the external mouse has been
connected correctly.
Restart the computer by using the keyboard.
, U, and select [Restart] with
(Press
If the computer does not respond to keyboard commands, read "No response"
( page 104).
Has the Setup Utility been used to set [Touch Pad] to [Enable]?
When external mouse drivers are installed (e.g., IntelliMouse), the touch pad
may not be used.
Has the touch pad driver been properly installed?
As a result of the physical characteristics of the touchscreen, sometimes the
position of the stylus does not match the position of the cursor on the screen.
This is not a malfunction. Perform [Calibration]. (
When mouse drivers are installed (i.e. IntelliMouse), the touchscreen is unable
to be used. Has the touchscreen driver been properly installed?
Has the touchscreen driver been properly installed?
Try changing the mute by pressing Fn+F4 or Fn+F6.
If the Windows sound function is not active, the volume will not change even if
is displayed.
Audio distortion may occur when operations are performed by pressing Fn in
combination with another key. Stop playing and start again.
103
, then press Enter.)
page 21)