Connecting Peripherals - Panasonic CF-52 Series Reference Manual

Troubleshooting (Advanced)
Wireless Communication (only for model with wireless LAN/Bluetooth/wireless
WAN)
Access point is not detected.
*4
In the case of wireless communications, the frequency band being used can be divided into segments, so that different communications
can be conducted on each band segment. A "Channel" refers to the individual frequency bandwidth divisions.

Connecting Peripherals

An error occurs while installing the
driver.
Shorten the distance between the computer and the access point, and try the
detection again.
Confirm the following settings:
• [Wireless LAN] in the [Advanced] menu of the Setup Utility
Confirm that [Wireless LAN] is set to [Enabled] (
• Wireless Switch
Slide the wireless switch to ON.
• Wireless Switch Utility
Confirm that Wireless LAN is ON (
Confirm that / /
If / / is not displayed on the notification area, turn on the wireless
communication ( page 72).
This computer uses channels 1 through 11
Check the channel being used by the access point.
When you install a driver of card or peripheral device, make sure that the driver
is compatible with the operating system. If it is not compatible, malfunction may
occur. For information about the driver, contact the manufacturer of the periph-
eral device.
Attach the device for the media containing the driver (e.g., CD-ROM). Equip-
ment connected to the multimedia pocket cannot be recognized if connected
after the device driver installation screen appears.
page
page 69).
is displayed on the notification area.
*4
when using IEEE802.11b/g.
105
82).