Table of Contents
Advertisement
.
Projecting
This section describes how to operate the unit to view a picture from the equipment connected
to the unit. It also describes how to adjust the quality of the picture to suit your taste.
Projecting the
Picture
1
Turn on both the unit and the
equipment connected to the unit.
2
Press INPUT to display the input
palette on the projection surface.
3
Select the equipment from which you
want to display images.
Press INPUT repeatedly or press M/m/
(enter) to select the equipment from
which to project.
Example: To view the picture from the
video equipment connected to the HDMI
1 connector of this unit.
Tips
• When "Status" is set to "Off" on the Setup
menu, the input palette does not appear.
Press the INPUT button to switch between
input terminals sequentially.
• You can change the language for the menu
and on-screen displays in "Language" on the
Setup
menu (page 32).
16
Projecting the Picture
Turning Off the Power
1
Press the ?/1 (ON/STANDBY)
button.
The message "POWER OFF?" appears.
2
Press the ?/1 (ON/STANDBY) button
again before the message disappears.
The LED indicator turns off.
You can disconnect the AC power cord.
Notes
• Never disconnect the AC power cord while
the unit is turned on.
• The LED indicator does not change when
"Illumination" is set to "Off" on the
Installation
menu,
You can turn off the unit by holding the ?/1
(ON/STANDBY) button for about 1 second,
instead of performing the above steps.
Advertisement
Table of Contents
