Table of Contents
Advertisement
• When adjusting the lens, each time you press
the LENS button on the unit, the lens
adjustment function switches as follows.
Note
Depending on the installation location of the
unit, you may not be able to control it with the
remote control. In this case, point the remote
control at the remote control detector of the
unit.
1
After connecting the AC power cord to
the unit, plug the AC power cord into
a wall outlet.
The unit goes into standby mode.
2
Press the ?/1 (ON/STANDBY) button
to turn on the unit.
The LED indicator lights in white.
Tip
The LED indicator does not light when
"Illumination" is set to "Off" on the Installation
menu.
3
Use the Picture Position function that
matches the projection size.
This setting is available in "Picture
Position" of the Screen
(page 30).
Image size
Installation
(for
distance
maximum
(from a
zoom)
projection
surface to
the rear of
the unit)
147- to
11 to 17 cm
132-inch
(4.3 to 6.7
inches)
132- to
6 to 11 cm
121-inch
(2.4 to 4.3
inches)
121- to
3 to 6 cm
113-inch
(1.2 to 2.4
inches)
113- to
0 to 3 cm
106-inch
(0 to 1.2
inches)
* Approximate adjustment value. When
the setting is overwritten in "Picture
Position" of the Screen
(page 30), it cannot be returned to the
default setting.
To perform further adjustment or change
the image size by using the zoom
function, follow the steps 4 to 6.
Adjusting the Projection Image
menu
Destination
for
adjustment*
Picture
Position
Custom 1
Picture
Position
Custom 2
Picture
Position
Custom 3
Default
setting
menu
9
Advertisement
Table of Contents
