Table of Contents
Advertisement
Using Network Features
Connection to the network allows you to operate the following features:
• Checking the current status of the unit via a Web browser.
• Making the network settings for the unit.
• Network monitoring and controlling with control protocol (SDAP [Advertisement],
SDCP [PJ Talk], DDDP [AMX], Crestron RoomView, Control4).
Notes
• When connecting this projector with the network, consult with the network administrator. The
network must be secured.
• When using this projector connected with the network, access the Control window via a Web
browser and change the access limitation of the factory preset values (page 41). It is recommended
to change the password regularly.
• When the setting on the Web browser is completed, close the Web browser to log out.
• The menu displays used for the explanation below may be different depending on the model you
are using.
• Supported Web browsers are Internet Explorer 8/9/10/11.
• The menu displays only English.
• If the browser of your computer is set to [Use a proxy server] when you have access to the unit
from your computer, click the check mark to set accessing without using a proxy server.
• AMX DDDP is not compatible with IPv6.
• These network functions are available when the unit is turned on.
Displaying the
Control Window of
the Unit with a Web
Browser
1
Connect the LAN cable.
LAN cable
(straight type)
(not supplied)
Hub, router, etc.
2
Set the network settings for the unit
using "Network Setting" on the
Installation
40
Displaying the Control Window of the Unit with a Web Browser
LAN
Connector
menu (page 38).
3
Start a Web browser on the computer,
enter the following in the address field,
then press the Enter key on your
computer.
http://xxx.xxx.xxx.xxx
(xxx.xxx.xxx.xxx: IP address for the
unit)
When connecting by the IPv6
address
http://[xxxx:xxxx:- xxxx]
You can confirm the IP address of the
unit under "Network Setting" on the
Installation
menu.
Advertisement
Table of Contents
