Table of Contents
Advertisement
fig.7
5.6 Conversions
Replacing the injectors
Our burners can be adapted to different
types of gas by simply installing the
injectors suitable for the gas you want
to use.
To change the injectors on the hob,
remove the burner cup and head and
with a 7 mm Ø socket spanner replace
them (fig. 8).
To help the installer, the table in the
"TECHNICAL INFORMATION" section.
gives the burner nominal heat input,
injector diameter and operating pressure
of the different gas types.
After having replaced the injectors,
it will be necessary to proceed with
burner adjustment as explained in the
previous paragraphs. The technician
must replace any seals after the
adjustments have been made.
fig.8
2
1
5.7 Maintenance
Prior to any maintenance work or
changing parts, disconnect the
appliance from the gas and electricity
power sources.
Replacing the taps
Proceed in the following way when
replacing a tap or the thermostat:
•
Remove pan supports, burner heads.
•
Unscrew the burner fixing screws
(fig. 11).(four for ultrarapid burner and
two for the other burners)
•
Remove the hob, unscrewing frontal
and rear fixing screws (
(fig. 11) which lock the hob .
•
Pull out the knobs.
•
Unscrew the nuts
aluminium pipes and pull out the
thermocouple quick connectors
(fig. 10).
•
Unscrew the screws
lock the crosspieces.
•
Unscrew the screws
unite the the bridles of the taps to the
front frame.
•
Make to slip the ramp toward the back
part and unscrew the screws
(fig. 9) in order to free the taps.
•
Change seal each time a tap or a
thermostat is replaced. This will ensure
perfect retention between the tap or a
thermostat and part.
•
Reassemble all the parts following the
same procedure but in the reverse
order.
2
1
fig.9
ENGLISH
21
1
,
,
)
4
3
2
of the gas
2
3
(fig. 10) which
2
(fig. 10) which
1
1
2
- Quick Links:
- Product Description
Hide quick links:
Advertisement
Table of Contents
