Integra DTR-40.7 Basic Manual page 82

Setting Item Default Value
Usage Data No
Network Check –
● Wait for a while if "Network" cannot be selected� It will appear when the network function is started up�
En-50
Setting Details
As a means of improving the quality of our
products and services, Onkyo may collect
information about your usage over the network�
Select "Yes" if you agree to our collecting this
information� Select "No" if you do not want us to
collect this information�
● You can set this after confirming the Privacy
Policy� When you select "Usage Data" and
press Enter, the Privacy Policy is displayed�
(The same screen is displayed once also
when setting up the network connection�) If
you agree to the collection of the information,
this setting also becomes "Yes"� Note that
if you agree to the Privacy Policy but select
"No" for this setting, the information will not be
collected�
You can check the network connection�
Press Enter when "Start" is displayed�
12V Trigger A
Set when outputting the control signal (maximum 12 V/100 mA) through the 12V TRIGGER
OUT A jack� Different settings can be set for each input selector� You can enable power link
operation when you connect the unit and the external devices equipped with 12V trigger
input jack�
Setting Item Default Value
Delay 0 sec
BD/DVD Main
CBL/SAT Main
STRM BOX Main
Advanced Settings (Setup Menu)
Setting Details
Set after how many seconds the 12V trigger
output will occur in response to the unit's
operation� As some devices cause a large
current when they turn on, delay the output if
such devices are connected� Select a value
between "0 sec" to "3 sec"�
Set the 12V trigger output setting to each
input�
"Off": No output
"Main": Output when "BD/DVD" is selected as
input for main room�
"Zone2": Output when "BD/DVD" is selected
as input for ZONE2�
"Main/Zone2": Output when "BD/DVD" is
selected as input for main room or ZONE2�
Set the 12V trigger output setting to each
input�
"Off": No output
"Main": Output when "CBL/SAT" is selected
as input for main room�
"Zone2": Output when "CBL/SAT" is selected
as input for ZONE2�
"Main/Zone2": Output when "CBL/SAT" is
selected as input for main room or ZONE2�
Set the 12V trigger output setting to each
input�
"Off": No output
"Main": Output when "STRM BOX" is selected
as input for main room�
"Zone2": Output when "STRM BOX" is
selected as input for ZONE2�
"Main/Zone2": Output when "STRM BOX" is
selected as input for main room or ZONE2�