Integra DTR-40.7 Basic Manual page 81

Network
Make the network setting�
● When LAN is configured with a DHCP, set "DHCP" to "Enable" to configure the
setting automatically� ("Enable" is set by default) To assign fixed IP addresses to each
components, you must set "DHCP" to "Disable" and assign an address to this unit in
"IP Address" as well as set information related to your LAN, such as Subnet Mask and
Gateway�
Setting Item Default Value
MAC Address –
DHCP Enable
IP Address –
Subnet Mask –
Gateway –
DNS Server –
Proxy URL –
Proxy Port –
Setting Details
This is the MAC address of the AV receiver�
This value is specific to the component and
cannot be changed�
"Enable": Auto configuration by DHCP
"Disable": Manual configuration without DHCP
● If selecting "Disable", you must set "IP
Address", "Subnet Mask", "Gateway", and
"DNS Server" manually�
Displays/Sets the IP address�
Displays/Sets the subnet mask�
Displays/Sets the gateway�
Displays/Sets the primary DNS server�
Displays/Sets the proxy server URL�
Displays/Sets the proxy server port number when
you enter "Proxy URL"�
Setting Item Default Value
Friendly Name DTR-40�7
AirPlay Password -----
Advanced Settings (Setup Menu)
Setting Details
Change the name for this unit to a simple one for
display on the equipment connected by network�
1� Press Enter to display the Edit screen�
2� Select a character or symbol with the cursors
and press Enter�
Repeat it to input 31 or less characters�
"A/a": Switches between upper and lower
cases� (Pressing +10 on the remote
controller also toggles between upper and
lower cases�)
"←" "→": Moves the cursor to the arrow
direction�
" ": Removes a character on the left of the
cursor�
"Space": Puts a space�
● Pressing CLR on the remote controller will
remove all the input characters�
3� After inputting, select "OK" with the cursors
and press Enter�
The input name will be saved�
You can enter a password (maximum of 31
places) so that only the entered user can use
AirPlay�
1� Press Enter to display the Edit screen�
2� Select a character or symbol with the cursors
and press Enter�
Repeat it to input 31 or less characters�
"A/a": Switches between upper and lower
cases� (Pressing +10 on the remote
controller also toggles between upper and
lower cases�)
"←" "→": Moves the cursor to the arrow
direction�
" ": Removes a character on the left of the
cursor�
"Space": Puts a space�
● Pressing D on the remote controller will
switch whether to mask the password with
" " or display in the plain text�
● Pressing CLR on the remote controller will
remove all the input characters�
3� After inputting, select "OK" with the cursors
and press Enter�
The input password will be saved�
En-49