Integra DTR-40.7 Basic Manual page 72

Setting Item Default Value
Back 0 dB
Subwoofer 0 dB
● The Speaker "Equalizer Settings" may be unable to be changed depending on the settings in
"Configuration" - "Speaker Channels" / "Subwoofer"�
● Adjust the volume of each speaker in "Level Calibration"�
● Adjust the volume in 1 dB steps�
● This is not effective if the listening mode is Direct�
● The result may not be as expected depending on the input source and listening mode setting�
THX Audio
Setting item Default Value
Back Speaker >4�0 ft or >1�2 m
Spacing
En-40
Setting Details
First select the frequency of the speaker from
"25 Hz" to "16 kHz" with the / cursors, then
use / to adjust the volume of the frequency
between "−6dB" to "+6dB".
● This cannot be selected if "Configuration" -
"Powered Zone 2" is set to "Yes" and Zone2
is set to on�
First select the frequency of the speaker from
"25 Hz" to "160Hz" with the / cursors, then
use / to adjust the volume of the frequency
between "−6dB" to "+6dB".
● This cannot be selected if "Configuration" -
"Subwoofer" is set to "No"�
Setting Details
Select the distance between the back speakers
from the following values�
When "Distance" - "Unit" is set to "feet"�: Select
a value from "<1�0 ft", "1�0-4�0 ft", and ">4�0 ft"�
When "Distance" - "Unit" is set to "meters"�:
Select a value from "<0�3 m", "0�3-1�2 m", and
">1�2 m"�
● This cannot be selected if "Configuration" -
"Powered Zone 2" is set to "Yes" and Zone2
is set to on�
● If an item cannot be selected even though
connection is correct, check that the settings
in "Configuration" - "Speaker Channels"
matches the number of connected channels�
Setting item Default Value
THX Ultra2/ No
Select2 Subwoofer
BGC Off
Advanced Settings (Setup Menu)
Setting Details
Set "Yes" or "No" of the connection of the THX
certified subwoofer�
"Yes": When a THX-certified subwoofer is
connected
"No": When a THX-certified subwoofer is not
connected
● The setting cannot be changed if
"Configuration" - "Subwoofer" is set to "No"�
If your listening room layout (for practical or
aesthetic reasons) locates most of the listeners
close to the rear wall, the resulting bass level
can be sufficiently reinforced by the boundary
that the overall sound becomes "boomy"� THX
Select2 Plus receivers contain a Boundary Gain
Compensation (BGC) feature to improve bass
balance�
"On": Use this function
"Off": Do not use this function
● In the following cases, the setting cannot be
changed:
– "Configulation" - "Subwoofer" is set to
"No"�
– "THX Ultra2/Select2 Subwoofer" is set
to "No"�