Integra DTR-40.7 Basic Manual page 104

measurement fails and the message "Ambient noise is
too high�" is displayed�
● This can be caused by a malfunction in your speaker
unit� Check if the unit produces normal sounds�
 The Late Night function does not work
¼
● Make sure the source material is Dolby Digital, Dolby
Digital Plus, Dolby TrueHD, or DTS�
 Re-EQ, Re-EQ(THX) function does not work
¼
● This function can be used in the following listening
modes: Dolby Digital, Dolby Digital Plus, Dolby TrueHD,
Multichannel, DTS, DTS-ES, DTS 96/24, DTS-HD High
Resolution Audio, DTS-HD Master Audio, DTS Express�
● In Re-EQ(THX), the following listening modes can be
used: THX Cinema, THX Surround EX, and THX Select2
Cinema�
 How do I change the language of a multiplex source
¼
● Select "Main" or "Sub" for "3� Audio Adjust" - "Multiplex/
Mono" - "Multiplex Input Channel"�
 Cannot connect to the AV receiver from a Web
¼
browser
● Make sure that the IP address of the AV receiver is
correctly input to the Internet browser�
● When DHCP is used for allocating the IP address, the IP
address of this AV receiver may have been changed�
● Make sure that both AV receiver and PC are properly
connected to the network�
 Power consumption in standby mode
¼
● In the following cases, the power consumption in
standby mode may reach up to a maximum of 4�4 W:
– When "Network Standby" in "6� Hardware" - "Power
Management" - "Network" is set to "On"�
– When "HDMI CEC (RIHD)" is set to "On"� (Depending
on the TV status, this unit will enter normal standby
mode�)
– The "HDMI Standby Through" setting is set to other
than "Off"�
– When "USB Power Out at Standby" is set to "On"
En-72
Troubleshooting