Leveling Procedure; Reel Bearing; Fan Belt (Diesel Engines) - Jacobsen Greens King IV Plus Parts & Maintenance Manual

3.15 LEVELING PROCEDURE ___________________________________________________

1. Lower the implements until they are about 1/4"
(6.35 mm) above the ground. If they are not level
with the ground, adjust torsion spring (Z).
WARNING
!
The torsion spring is under extreme tension and will
tend to uncoil very rapidly if the clamp is loosened. To
prevent being cut by clamp or spring, unwind spring
by tapping on clamp while slowly loosening nut.
2. Carefully loosen spring mounting clamp and slowly
turn clamp until implement is level. Tighten clamp
securely.

3.16 REEL BEARING ___________________________________________________________

Any end play or radial play indicates bad bearings, a
weak tension spring or a backed off nut.
1. Check bearing housing mounting hardware. Tighten
or replace components as required. Carefully clean
threads with degreaser.
2. Apply a medium strength grade of Loctite to nut (AA),
then thread nut onto the reel shaft until the nut is
1-27/32" (46 mm) from the end of the reel shaft.
3. Fill reel bearing housings with NLGI - Grade O
grease after adjusting spring.

3.17 FAN BELT (DIESEL ENGINES) _______________________________________________

Inspect and adjust new belt after first ten hours of
operation. Adjust every 100 hours thereafter.
1. Adjust alternator pulley so belt (B) deflects 9/32 to
11/32 in. (7 to 9 mm) with a 22 lb. (10 kgf) push at
mid span between pulleys.
2. If tension is incorrect, loosen alternator mounting
bolts (A) and adjust alternator until proper belt
tension is achieved. Tighten hardware (A)
ADJUSTMENTS
Z
AA
1-27/32"
(46 mm)
3
Clamp
GKV-10
Figure 3M
AA
GKV-11
Figure 3N
A
B
Figure 3O
GB-13