Yamaha Portable Grand DGX-660 Owner's Manual page 14

Keyboard Stand Assembly
4
t
6 x 30 mm roundhead screws
5
Be sure to place your hands at
least 10 cm from either end of the
keyboard when positioning it.
At least
10 cm
14
DGX-660 Owner's Manual
At least
10 cm
4
Attach the back board.
Attach the back board, using the screws
the back-to-front orientation for the side boards.
Make sure the non-colored surface is facing down.
CAUTION
• Be careful not to drop the back board or touch the
sharp metal fittings.
NOTE
• If you have purchased a pedal unit (sold separately),
attach the pedal unit before proceeding to the next step.
Refer to the instructions provided with your pedal unit.
• For information on the pedal functions, refer to page 22.
5
Put the keyboard on the stand.
Check the back-to-front orientation for stand, and
carefully place the keyboard on the side boards.
Slowly move the keyboard so that the holes on the
bottom of the keyboard are properly aligned with
the holes on the angle brackets.
CAUTION
• Be careful not to drop the keyboard or to get your fin-
gers caught between the keyboard and the stand
parts.
• Do not hold the keyboard in any position other than
the position shown in the illustration.
t . Check