Gorenje GC31WTB User Manual page 42

TROUBLESHOOTING INDUCTION HOB
Symptom
The cooking zone suddenly
stops working and you hear
a signal.
The hob is not working
and nothing appears in the
display.
A fuse blows as soon as the
hob is switched on.
Fault code F00.
Fault code F0 ... F6 and FC.
Fault code F7.
Fault code F8 and F08.
Fault code F9 and/or
continuous beep.
Fault code F99.
Fault code FA.
Fault code FAN.
Fault code E6 (IT31W)
Other fault codes.
GB 42
Possible cause
The preset time has ended.
There is no power supply
due to a defective cable or a
faulty connection.
The hob has been wrongly
connected.
The control panel is dirty or
has water lying on it.
Defective generator.
The ambient temperature is
not good.
Appliance over heated.
The appliance has been
connected incorrectly and/or
the mains voltage is too high.
You have pressed two or
more buttons at the same
time.
Mains voltage is too low.
Air circulation not good.
Wrong pan.
Hardware / software error.
Defective generator.
Solution
If you want to continue
cooking, switch on the
cooking zone again.
Check the fuses or the
electric switch (if there is no
plug).
Check the electrical
connections.
Clean the control panel.
Contact the service
department.
Switch off all heat sources
in the vicinity of the cooking
plate.
The appliance has been
switched off because of over
heating. Let the appliance
cool down and start again on
a lower setting.
Let your connection be
changed.
Do not operate more than
one button at the same time.
Contact your energy supplier.
Make sure the venting holes
under the cooking plate are
open.
Suitable pans are available
via Gorenje.
Contact the service
department.
Contact the service
department.