Information Codes - Samsung WF50K7500A SERIES User Manual

Information codes

If the washer fails to operate, you may see an information code on the screen. Check the
table below and try the suggestions.
Code
1C
dC
DC1
LC
4C
4C2
WF7500K-000000-00_EN.indd 55
Check the water level sensor.
• Power off and power the machine on after 2-3 minutes, and
then try again.
• Depending on the model, the drain system drains water
automatically. The POWER and START/PAUSE buttons may be
disabled during this process.
The door is open.
• Close the door and press START/PAUSE to resume operation.
Check the door switch.
• Power off and power the machine on after 2-3 minutes, and
then try again.
Check for water leaks.
• Power the machine off and check the drain system for any
leak. Once the leak is solved, power the machine on after 2-3
minutes.
• Depending on the model, the drain system drains water
automatically. The POWER and START/PAUSE buttons may be
disabled during this process.
Check the water supply line.
• Check for the connection of the water line (including water
taps).
• Power off and power the machine on after 2-3 minutes, and
then try again.
• Depending on the model, the drain system drains water
automatically. The POWER and START/PAUSE buttons may be
disabled during this process.
Laundry needs protection because the water being supplied is
too hot.
• Make sure the cold and hot water taps are properly
connected.
• Power off and power the machine on after 2-3 minutes, and
then try again.
Action
English 55
2016-01-14 4:33:43