Door diaphragm
CAUTION
You must handle and care the bleach as instructed by the bleach manufacturer.
Recovery from freezing
The washer may freeze when it drops below 0 °C.
1. Turn off the washer, and unplug the power cord.
2. Pour warm water over the faucet to loosen the water hose.
3. Disconnect the water hose, and soak it in warm water.
4. Pour warm water into the drum and leave it for about 10 minutes.
5. Reconnect the water hose to the faucet.
NOTE
If the washer still doesn't operate normally, repeat the above steps until it operates
normally.
Care against an extended time of disuse
Avoid leaving the washer unused for an extended time. If this is the case, drain the
washer and unplug the power cord.
1. Turn the Cycle Selector to select RINSE+SPIN.
2. Empty the drum, and press START/PAUSE.
3. When the cycle is complete, close the faucet and disconnect the water hose.
4. Turn off the washer, and unplug the power cord.
5. Open the door to let air circulate through the drum.
WF7500K-000000-00_EN.indd 49
A
1. Open the door and empty the drum.
2. Turn out the diaphragm (sealing or
gasket of the drum (A)), and check if it
is stained. If so, follow the steps below.
3. Prepare a cloth with a combination of
3/4 cup of liquid chlorine bleach and 1
gallon of warm tap water.
4. Wear rubber gloves and use the cloth
to clean the diaphragm.
5. Let stand for 5 minutes, and then wipe
up and dry well.
English 49
2016-01-14
4:33:43