Samsung WF50K7500A SERIES User Manual page 22

Installation
STEP 3 Adjust the levelling feet
STEP 4 Connect the water hose
22 English
WF7500K-000000-00_EN.indd 22
1. Gently slide the washer into position.
Excessive force may damage the
levelling feet.
2. Level the washer by manually adjusting
the levelling feet.
3. When levelling is complete, tighten the
nuts using the wrench.
NOTE
An adjustable wrench or 17 mm open-
end wrench is required to loosen or
tighten the leveling feet.
CAUTION
• Make sure you use a new water hose,
and there are rubber gaskets (B) inside
the couplings (A) at either end of the
water hose. A water hose without the
gasket may cause a water leak.
• If there is a water leak, stop using the
washer and contact a local Samsung
service center. This may cause electric
B
shock.
• Do not stretch the water hose by force.
If the hose is too short, replace the hose
with a longer, high-pressure hose.
A
• To prevent leaks, make sure both water
hoses are not bent or kinked. A water
leak may cause electric shock.
2016-01-14 4:33:38