Do you have a question about the WV55M9600AV and is the answer not in the manual?
Questions and answers
Roxana
March 25, 2025
How to unlock top washer door , error message 1dC4
3 comments:
Mr. Anderson
March 25, 2025
Close the protective cover, then press START/PAUSE to resume operation.
This answer is automatically generated
Roxana
March 26, 2025
@Mr. Anderson
Roxana
March 26, 2025
@Mr. Anderson , I have done that, also drained all the water from the little hose located at the bottom left front little door. The top lid couldn’t open after the cycle was finished.
Paolo Tonzini
June 12, 2025
My flex washer started to not powering up about a week ago then if I kept pushing the power button it would occasionally turn on then turn off after about 5 seconds, but if I started a load immediately it would run fine. Now about a week later will not power up at all. I checked the noise filter with meter seems to be fine, swapped the main board in the back and both control boards in the front still won't power on what else could it be?
Need help?
Do you have a question about the WV55M9600AV and is the answer not in the manual?
Questions and answers
How to unlock top washer door , error message 1dC4
Close the protective cover, then press START/PAUSE to resume operation.
This answer is automatically generated
@Mr. Anderson
@Mr. Anderson , I have done that, also drained all the water from the little hose located at the bottom left front little door. The top lid couldn’t open after the cycle was finished.
My flex washer started to not powering up about a week ago then if I kept pushing the power button it would occasionally turn on then turn off after about 5 seconds, but if I started a load immediately it would run fine. Now about a week later will not power up at all. I checked the noise filter with meter seems to be fine, swapped the main board in the back and both control boards in the front still won't power on what else could it be?