Samsung WF50K7500A SERIES User Manual page 17

Drain
Samsung recommends a standpipe in
height of 18 in (46 cm). The drain hose
must be connected through the hose clip
to the standpipe, and the standpipe must
fully cover the drain hose.
Flooring
For best performance, the washer must
be installed on a solid floor. Wood floors
may need to be reinforced to minimize
vibration and/or unbalanced loads.
Carpeting and soft tile surfaces are not
a good resistance to vibrations and may
cause the washer to move slightly during
the spin cycle.
CAUTION
Do NOT install the washer on a platform or
a poorly supported structure.
Water temperature
Do not install the washer in areas where
water may freeze as the washer always
retains some water in its water valves,
pumps, and/or hoses. Frozen water left in
the connection parts may cause damage to
belts, the pump, and other components of
the washer.
WF7500K-000000-00_EN.indd 17
Alcove or closet installation
Minimum clearance for stable operation:
Sides 1 in. (25 mm)
Top 17 in. (432 mm)
Rear 5.9 in. (150 mm)
Front 2 in. (51 mm)
If both the washer and a dryer are
installed in the same location, the front of
the alcove or closet must have at least a
72 in² (465 cm²) unobstructed air opening.
Your washer alone does not require a
specific air opening.
English 17
2016-01-14 4:33:37