Table 1-2 Wrench Size And Torque Values - Keysight n1921a Operating And Service Manual

1 Introduction
Figure 1-2
Allow a few seconds for the power meter to read the data contained in the power
sensor's EEPROM.
Ensure power sensor cables are attached and removed in an indoor environment.
NOTE
Torque
Table 1-2
models. A torque wrench must be used to tighten these connectors. Only use a
wrench set to the correct torque value.
Table 1-2 Wrench Size and Torque Values
Model
N1921A
N1922A
18
Connecting a Sensor Cable to a Power Meter
shows the connector type (for connection to DUT) for the power sensor
Connector
Type-N (male)
2.4 mm (male)
Keysight N1921A and N1922A Operating and Service Guide
Ensure you line up the red dots on the sensor
cable and power meter's connector
Wrench Size
3/4-inch open-end
5/16-inch open-end
Torque Value
12 in-lb (135 Ncm)
8 in-lb (90 Ncm)