Power Meter and Sensor Cable Requirements
The P-Series Wideband Power Sensors are ONLY compatible with the P-Series
Power Meters.
Table 1-1
requirements, as the cable is permanently connected (hard-wired) to the P-Series
Wideband power sensor.
Table 1-1
Cable Length Options
Option
N1921A-105
N1922A-105
N1921A-106
N1922A-106
N1921A-107
N1922A-107
Interconnections
Connect the cable to the P-Series power meter's channel input.
that you must align the red dot on the sensor's cable and the meter's connector.
BEFORE CONNECTING THE POWER SENSOR TO OTHER INSTRUMENTS
WARNING
ensure that all instruments are connected to the protective (earth) ground.
Any interruption of the protective earth grounding will cause a potential
shock hazard that could result in personal injury.
Recommended Calibration Interval
Keysight Technologies recommends a one-year calibration cycle for the P-Series
power sensors.
Keysight N1921A and N1922A Operating and Service Guide
lists the length of cable option, these have no interconnecting cable
Description
1.5m (5-ft) cable length
3m (10-ft) cable length
10m (31-ft) cable length
Introduction
1
Figure 1-2
shows
17