Keithley 3720 User Manual page 31

Series 3700 System Switch/Multimeter User's Manual
x
x
x
If patterns (or a pattern) have already been created, pressing this key once will allow you to
scroll through and select a pattern. Pressing this key a second time opens the PATTERN
ACTION MENU (as described above).
PATT key configuration
Pressing the CONFIG key and then the PATT key opens the PATTERN ATTRibute MENU. This
menu contains the following item:
x
SLOT key
Press this key to display installed card(s) and instrument information, as well as main system
information. The information displayed includes firmware revisions of both main and installed
components. After pressing this key, scroll through all available instruments, including the
internal DMM.
SCAN key
If a scan list is present, this key opens the SCAN ACTION MENU that contains the following
menu items:
NOTE
x
x
x
x
x
Document Number: 3700S-900-01 Rev. A / August 2007
VIEW: This menu item shows the channels associated with the pattern. Note that if no
patterns exist in the system when the PATT key is pressed, then this will be the only
menu item displayed in the PATTERN ACTION MENU. Related ICL command:
channel.pattern.getimage
DELETE: This menu item deletes a channel pattern. Related ICL command:
channel.pattern.delete
RESET: This menu item resets channel pattern aspects of the system to factory default
settings. Resetting a channel pattern will cause each channel and backplane relay of the
pattern image to be reset back to factory default settings. Also, the pattern will be deleted
because resetting a channel causes any patterns that contain a channel being reset will
be deleted. Related ICL command: channel.reset
DMM_CONFIG: This menu item sets the DMM configuration associated with the
channels specified. Related ICL command: dmm.setconfig
Use the INSERT key to create and add the present active channel to the scan list.
EXECUTE: This menu item runs the scan. Related ICL command: scan.execute
CREATE: This menu item displays following message: Use <INSERT> key
LIST: This menu item displays the scan list (turn the wheel to scroll). Related ICL
command: scan.list
CLEAR: This menu item clears the scan list. Related ICL command: scan.create (send
with an empty string)
RESET: This menu item resets the scan settings to factory default values. Related ICL
command: scan.reset
Section 2: Using the Front Panel
2-9