Yanmar 4JH2E Service Manual page 275

Chapter 7 Reduction and Rerersing Gear
6. Reassembly
(S)lnsert the outer bearing race, shim and the output
shaft cover, and tighten the bolt.
(6)1nsert the oil
0-ring
(7)Tighten the end nut with the special tool and a tor-
que wrench, then calk
it.
Torque wrench
/
Special tool
Socket
Output shaft coupling lock
Tightening torque
Socket wrench
Output shaft coupling
54 - 56 kg-m
(391 - 405 ft-lb)
7-60
4JH Series.
6-3-7 Reassembly of the shifting device
{ 1) Fit the oil seal and 0-ring to the side cover
0-ring
Oil seal
(2)1nsert the shift lever shaft to the side cover
(3)Fit the shift lever to the shift lever shaft
NOTE: Check the direction of the shift fever
6
mark.
6
mark
(4)1nsert the shifter spring and shifter to the shift
lever shaft
Printed in Japan
AOA/029-9002