Yanmar 4JH2E Service Manual page 228

Chapter 7 Reduction and Reversing Gear
5. Disassembly
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~4Jlf Series
5. Disassembly
5·1 Disassembling the clutch and accessories
(1) Remove the drain plug and packing, and drain the oil
from the clutch.
(2) Uncaulk the output shaft lock nut, and remove the nut
using a disassembly tool.
Socket
(177075-09020)
Output shaft coupling lock
(177075·09050)
,-------
/
Socket wrench
Output shall
coupling
lock---,>7"'/
Socket wrench
(3) Remove the output coupling with O·ring.
Output shaft
Output shaft ooupllng
(4) Remove the dipstick and packing.
(5) Remove the case cover MB nut and MB bolt;
remove the case cover, with the operating lever, shift
cam, etc. in position.
Printed in Japan
A0AJ029-9002
7-13
(6) Remove the M10 bolt and super lock washer on the
mounting flange.
(7)
Screw the M10 bolt into the M10 pulling bolt hole of
the mounting flange, and remove the mounting flange.
Do not remove the parallel pin.
Input shaft
Intermediate shaft
Output shaft
(B) Remove the output shaft, intermediate shaft, and input
shaft from the case, in that order.
(9) Remove the shift bar from the moving flange side.
Output shaft assembly
Intermediate shaft assembly
Input shaft assembly