Yanmar 4JH2E Service Manual page 272

Chapter 7 Reduction and Rerersing Gear
6. Reassen:bfr
6-3 Reassembly of the clutch case
6-3-1 Reassembly of the intermediate shaft
{1)Drive ijj the outer bearing race
{,large)
in~()
tha
c!u~ch
case.
8-
1 I
~
'""" "'
!00,
,, ,_
(2) Insert the inner bearing races and idle gear
and drive in the interniediate shaft
(3)Drive the outer bearing race into the clutch case.
Inserting tool
- - - <
Bearing race
rrT-'iloi~~.,.---
(4)1nsert the washer and tighten the end nut using a torque
wrench.
Tightening torque
8.5 - 11.5 kg-m
(61.5
-83.2
ft-lb)
NOTE: Remember it is a left-handed thread
Printed in Japan
AOAJ029-9002
7-57
4JH Series.
(5)Calk the end nut
(6)lnsert the shims into the clutch case.
6-3-2 Reassembly of the bearing outer races and
shims in the clutch case
(l)Orive the input shaft outer bearing race and clutch
shah outer bearing race into the clutch case.
(2)1nsert the clutch shaft shim, lube oil filter case and filter
into the clutch case.
..0_--
Lube
oil filter
v - L u b e
oil filter case