The First Run Experience; All Set - Flashforge Creator Quick Start Manual

You're done with initial hardware setup!

The First Run Experience

All set?

First, make sure that you've completed all the steps in the Unboxing and Hardware
Setup section: your DualExtruder should be bolted in place, your filament guide
tubes connected, and your spools of filament mounted on the spool holders. You can
plug in your power supply now, too.
If everything is ready, then flip on the power button on the back of your Creator.
The Creator will now guide you through initial setup and your first print. You should
see a welcome message on the LCD screen.
If you don't see something like that, don't worry -- just go to Utilities->Run Startup
Script. Use the up and down keys to move the cursor and push the M to select.
First the startup script will teach you a few basic things about how The Creator works.
Then it will help you level the platform, load filament, and start a test print.
Because the Creator has been tested and calibrated in the factory before being sent
out, so the following setting-up instructions may not appear, but you can also use
all these functions directly by select them on the menu.
Follow the on-screen instructions to set up your Creator for the first time! Leveling