Unboxing; Package Contents - Flashforge Creator Quick Start Manual

Unboxing

We packaged your Creator very carefully -- we hope you'll read this guide and be just
as careful unpacking it. In fact, you should always be really careful with The Creator.
Here are a few things to keep in mind.

Package Contents

Here are the items that should be found in the Creator package:
-The Creator
-Dual Extruder
-Feet, Bolts and Hex Wrench Kit
-2x spool holders
-Power supply cable
-USB A to B cables
-2x filament guide tubes
Unboxing
First, place The Creator's box on the ground next to a clean, flat workspace. Discard
the top cardboard insert, if you haven't already. Now remove the inner cardboard
box -- the one that fits around the outside of The Creator.
You'll be able to see the top of The Creator now, as well as some cardboard boxes
and packaging. Note: the black cable is not a handle! Never lift The Creator by the
black cable.
Lift it up from the outside. Grasp the upper frame carefully and avoid touching the
internal belts and rods. Gently pull The Creator out of its packaging and place it on
your work surface.