Loading Filament - Flashforge Creator Quick Start Manual

It's very important that you always move two knobs during each step -- if you try to
move only one knob at a time, the script can have unexpected results. Also, make
sure that you're moving the specific knobs the script is telling you to use.
At each stage of the script, your Creator will ask you to test the platform height by
sliding a piece of paper between the platform and nozzle.
When you're done, The Creator will ask you if the nozzle height is OK.
Use the sticky note to test the platform height one last time. If the note can move up
and down underneath the nozzle, your platform is too low; select "Let's try again." If
it can slide around a little bit, you're good to go.
If your platform is too low, your prints might not stick to the surface, and if it's too
high, the nozzles could tear the Kapton tape on the platform surface. If you're having
trouble, or if you just need to level your platform again, you can always get back to
the leveling script in the menu by going to Utilities->Level Build Plate

Loading Filament