Using A Usb Wireless Lan Module; Attaching The Ifu-Wlm3; Making A Wi-Fi Connection - Sony PXW-Z100 Operating Manual

Replacing an XQD memory card
• If the available time on two cards in total
becomes less than 5 minutes, the warning
message "Media Near Full" is displayed, the
recording lamp flashes, and a beep sound is
output to the headphones to warn you. Replace
the cards with those that have sufficient space.
• If you continue recording until the total
remaining time reaches zero, the message
changes to "Media Full," and recording stops.
Notes
• Up to approximately 600 clips can be recorded on one
XQD memory card.
If the number of recorded clips reaches the limit, the
remaining time indication becomes "0," and the
message "Media Full" is displayed.
20

Using a USB Wireless LAN Module

Using a USB Wireless
LAN Module
You can make the Wi-Fi connection between the
camcorder and a device such as a smartphone,
tablet, etc., by attaching the supplied IFU-WLM3
USB wireless LAN module.
Notes
• You cannot use a USB wireless LAN module other
than the IFU-WLM3.
Making a Wi-Fi connection between a device and
the camcorder enables you to do the following.
• Record and playback the camcorder
• Display the current status of the camcorder
• Switch between the recording settings and
system settings
• Operate the assignable buttons of the camcorder
• Operate the iris, focus and zoom

Attaching the IFU-WLM3

1
Open the cover of the USB wireless
LAN module retracting part (page 9).
2
Insert the IFU-WLM3 to the USB
connector.
3
Close the cover.
Notes
• The IFU-WLM3 cannot be removed easily once
attached. Use with the IFU-WLM3 attached.

Making a Wi-Fi connection

Notes
• Only one Wi-Fi device can be connected at a time.
Making a network setting
Change the "Basic Authentication" settings
(page 50) of the System menu as required.
Item Setting
User Name User name for log-in (factory default
setting: "admin")
Password Password for log-in (factory default
setting: model name "pxw-z100")