Setting The Clock; Attaching Devices; Attaching The Supplied Microphone - Sony PXW-Z100 Operating Manual

Setting the Clock

When you turn the camcorder on for the first time
after purchasing or the backup battery has
completely discharged, the Initial Setting display
appears on the viewfinder screen and LCD
screen. Set the date and time of the built-in clock,
using this display.
Time Zone
The value shows the time difference from UTC
(Coordinated Universal Time).
Change the setting if needed.
Setting the time and date
Clock starts after you turn the SEL/SET dial
(page 9) to select the items or value, then press
the SEL/SET dial to set them.
After the setting display disappears, "Clock Set"
(page 50) in the System menu can be used to set
"Time Zone" and date/time.
Notes
• If the clock setting is cleared because the backup
battery fully discharged when no power was supplied
(no battery pack and no DC IN connection), the Initial
Setting display will be displayed when you next turn
the camcorder on.
• While the Initial Setting display is shown, no other
operation, except turning the power off, is permitted
until you finish the setting for this display.
16 Setting the Clock / Attaching Devices

Attaching Devices

Attaching the supplied
microphone
When you use the supplied microphone (ECM-
XM1) for recording sound, do the following
steps.
1
Attach the wind screen B to the
supplied microphone A.
2
Place the microphone A in the
microphone holder C with the model
name facing upward, close the cover,
and shut the clamper.
3
Connect the plug of the microphone to
the INPUT1 connector D.
4
Put the microphone cable into the cable
holder E.