Foreword; S E C T I O N 3 G E N E R A L W A R N I N G - Eurotrac W10 Operation Manual

Section 3 GENERAL WARNING

FOREWORD

This instruction manual is intended for all users of the machine: the company
manager, the Department Head, the driver, as well as the whole personnel who
works with or near to the equipment
GENERAL WARNING:
1. Before using the machine, go through this manual and comply with all its instructions
2. Also carefully read the instructions that appear on the plates fixed onto the machine and keep
them readable
3. Keep this instruction manual at the disposal of all operators
4. Make sure that any person to whom you entrust the machine is qualified to fulfill the safety
requirements linked to its use
5. Avoid unsupervised interventions on your equipment when not being used
6. Never use a machine which does not looks to be in good condition
7. Never apply a load or a stress exceeding the maximum operating load of the machine
8. Never use the machine for an operation it is not designed to perform
9. Become thoroughly familiar with the safety regulations applicable to the machine and enforce
them scrupulously
10.The manufacturer declines his responsibility for the consequences of a disassembly of the
machine or any modification made without his supervision
OBLIGATION TO GO THROUGH THE USER'S MANUAL
The company manager is compelled to make the operators fully acquainted with the
regulations of the instruction manual.
Read this entire chapter BEFORE attempting to operate this loader
The company manager is responsible for the enforcement of the applicable "user's
regulation"
The user must imperatively read and assimilate this instruction manual in order to be able
to comply with it during start- up and use
The instruction manual must be kept during the life- span the machine, including in the
event of a resale, of a change of user or manager
The instruction manual is not a training manual but it specifies, when required, if training
is necessary.
The company manager must make sure that the machine is delivered with the
instruction manual and the certificate of conformity for the member states of the European
Community
* The location of the instruction manual is specified on the dispatch note when leaving
the factory
The certificate of conformity is placed with the dispatch note
Only trained and qualified operators with appropriate driving license and accredited by
the company manager may operate the vehicle within the scope of the use for which it
has been designed
The loader may only be used in accordance with the conditions established by the
manufacturer in this instruction manual and declines the manufacturer his responsibly.
Any use that does not comply with the regulations of this instruction manual might cause
risks of injury to people, property and the environment
The manufacturer's responsibility is limited to the assembly configuration of the
equipment as described in the certificate of conformity. Before each use, the driver should
Page 7/47
W10 series loader operation manual
GENERAL INSTRUCTION
JST
Series
Updated 10/6/2016