Section6 Storage Procedure - Eurotrac W10 Operation Manual

(draw bar) to connect with trailer.
Trailer Steps
-Place the skids (wedge) after the slip edge at the wheel.
-Lower the goods until the cargo compartment does not hit the ground while working.
-Removing the goods and attachments.
-Starting the tractor.
-Using the rigid drawbar to connect the tractor (with adequate traction and braking force) with
the traction pin which located on the counterweight back side of the loader.
Release hand brake
Open the manual bypass valve on the plunger pump
After traction
-Use the wedge to wedge the wheel slip.
-Tighten hand brake
Restore the braking force
-Tighten the manual bypass valve
- Install a the seat mounting plate
After repairing, check the brake function.

The focus point of the machine salvage can be the vehicle lifting point, the
traction point when dragged is in the back of counterweight. The allowed
maximum force points value : 10KN.
This machine can be used for short-drag powerless trailer:
1. The location of Traction is at the rear of counterweight.
2. The maximum traction value of this machine is: 5.2KN

3. Maximum traction speed is ≤ 5km / h
4. Just only allows rigid drawbar traction
5. Not for long traction
6. When used as a tractor, please pay close attention to the hydraulic oil
temperature, can't exceed the maximum temperature of piston pump.
Section 6: Storage procedure
Piston pump
Driving axle
Tyre
Page 30/47
W10 series loader operation manual
one month
No special attention
No special attention
Loader must be raised or put
blocks under the wheel axle,
prevent tyre from contacting the
ground. Tyre pressure must be
reduced to 15 PSI.
JST
Series
indefinite duration
Discharge the oil in piston pump.
Refill piston pump with oil.
Dismantle oil extraction
differentiator shell to discharge of oil of
drive axle, remounted
discharge.
Loader must be raised or put blocks
under the wheel axle, prevent tyre from
contacting the ground. Tyre pressure
must be reduced to 15 PSI and sprayed
with rubber preservative.
plug under
plug after
Updated 10/6/2016