S E C T I O N 2 O P E R A T I N G P R O C E D U R E - Eurotrac W10 Operation Manual

SECTION 2: OPERATING PROCEDURE
Read this entire chapter BEFORE attempting to operate this loader
－No unauthorized person may drive this loader
－Be familiar with the controls and their functions before you start the loader
－Inspect your machine by doing a pre-operational inspection
－Observe the limits on weight of the loads to be towed and unloaded weight of the loader
－ Maintain the loader in accordance with the instructions of the manufacturer
－Have any broken or missing parts, correct or replace before use
－Verify that all maintenance has been performed
－Verify that all the instruction and safety labels are in a place and readable
These are as important as any other equipment on the loader
Before putting the loader into service, the following items must be checked and executed
BEFORE DRIVING
●
At each team work beginning, check condition of the battery, pneumatic and bandages of trails
and be sure that tire pressures are correct .Be sure that all driving parts are in good working
condition and fill all the fluid levels if necessary .Advise immediately all defects and use a
defective trail before it is not repaired Verify the brakes of trails
●
Set parking brake
●
Walk around and inspect the loader for damage or missing equipment
Check for :
- Pressure and the good state of the pneumatic tires
- Look for cuts, cracks in side walls, foreign objects in treads
- Look for loose wheel nuts
- Damage to lights
- Fire extinguishers fully loaded and in place (if have)
●
Look underneath loader for leaks of coolant, hydraulic fluid, transmission fluid, or lubricating
oil. If leaks are detected, repair as soon as possible
●
Check engine oil level
●
Check engine coolant level. Add coolant as necessary, but do not overfill. Make a visual check
for leaks
●
Check hydraulic system reservoir by removing filler cap to ensure there is enough fluid for
operation
A very low fluid level indicates a serious leak in the system. Repair as soon as possible
●
Inspect engine compartment for loose hardware, loose wires, and leaking lines or fittings
●
When all mechanical checks are completed, check the operation of the stop and tail lights,
head
lights, and dash panel lights
●
Check fuel level gauge to make sure tank is full
●
Make sure the roll cage arise and fasten.
●
Check that the driving seat whether damaged (change the seat if damaged), adjusted to your
requirements
●
Check that all controls are in working order
WARNING: DO NOT LOOSEN OR REMOVE RADIATOR CAP WHILE COOLANT IS HOT,
HOT COOLANT UNDER PRESSURE CAN CAUSE SEVERE BURNS
Page 18/47
W10 series loader operation manual
JST
Series
Updated 10/6/2016