Specifications - Emotiva basX A-100 User Manual

X -100
A
BAS

Specifications

Analog inputs: Unbalanced (RCA); one stereo pair
Analog outputs (loop): Unbalanced (RCA); one stereo pair
Input sensitivity (for full output): 600 mV (8 ohm load)
Speaker outputs: 5-way binding posts; one stereo set
Minimum recommended load impedance:
4 ohms (which equals one 4 ohm load or two paralleled 8 ohm loads per channel)
Power output:
50 watts / channel RMS; 8 Ohms; 20 Hz - 20 kHz; <0.05% THD; both channels driven (FTC)
80 watts / channel RMS; continuous; into 4 ohms
Headphone output:
Front panel jack; full sized 1/4".
Headphone output is derived from the main speaker outputs via high quality 220 Ohm resistors.
Optional high-power mode for driving low-efficiency planar headphones.
S/N ratio: > 110 dB (A-weighted; ref full output)
Frequency response: 20 Hz to 20 kHz + / - 0.08 dB at 1 watt (- 1 dB at 80 kHz)
Front panel controls and indicators:
Volume; analog potentiometer with machined aluminum knob and illuminated status ring
Rear panel controls:
AC Power switch
Line Voltage (protected slide switch)
Trigger Switch (mode) (On, Off, Auto)
Trigger and control:
Trigger Input: 5-12 VDC
Auto-sense of audio input signal
Trigger Output: direct hardware feed through of input trigger signal
Protection:
The BASX A-100 is protected against all common fault conditions.
The status ring will blink amber when a fault is detected.
Power requirements:
115 VAC or 230 VAC +/- 10% @ 50 / 60 Hz (selectable by rear-panel switch)
Dimensions:
8.5" wide x 3.125" high x 15" deep (includes feet, binding posts, and Volume knob)
Weight:
11.8 lbs ; 15 lbs (packaged)
Page 16