Technical Specifications - HP ProLiant BL685c Generation 7 Quickspecs

QuickSpecs

Technical Specifications

System Unit System Unit System Unit System Unit Dimensions Dimensions Dimensions Dimensions
(H x W x D)
Weight Weight Weight Weight
(approximate)
Power Specifications Power Specifications Power Specifications Power Specifications
System Inlet Temperature System Inlet Temperature System Inlet Temperature Operating System Inlet Temperature
Relative Humidity Relative Humidity Relative Humidity Relative Humidity
(non-condensing)
Altitude Altitude Altitude Altitude
Acoustic Noise Acoustic Noise Acoustic Noise Acoustic Noise
DA - 13655 North America — Version 19 — September 26, 2011
HP ProLiant BL685c Generation 7 (G7) Server Blade HP ProLiant BL685c Generation 7 (G7) Server Blade HP ProLiant BL685c Generation 7 (G7) Server Blade HP ProLiant BL685c Generation 7 (G7) Server Blade
14.42 x 2.19 x 20.058 (36.63 x 2.19 x 50.95 cm)
Maximum
(all hard drives, DIMMs,
and processors installed)
Minimum
(no hard drives, two
processors and four
DIMMs)
For power specifications including input requirements, BTU rating, and
power supply output, please see the HP BladeSystem c-Class Enclosures
QuickSpecs located at:
HP BladeSystem c3000 Enclosure QuickSpecs:
http://h18000.www1.hp.com/products/quickspecs/12790_na/
12790_na.html
HP BladeSystem c7000 Enclosure QuickSpecs:
http://h18000.www1.hp.com/products/quickspecs/12810_na/
12810_na.html
To review typical system power ratings use the HP BladeSystem Power Sizer
available at: http://www.hp.com/go/bladesystem/powercalculator
NOTE: NOTE: NOTE: NOTE: For optimal cooling and system performance the BL685c G7
requires the c7000 enclosure to be configured with 10 fans and the c3000
enclosure to be configured with 6 fans.
Non-operating
Operating
Non-operating
Operating
Non-operating
For acoustic noise specifications, please see the HP BladeSystem c-Class
27 lbs (12.25 kg)
19.2 lbs (8.71 kg)
10° to 35°C (50° to 95°F) at sea level with an
altitude derating of 1.0°C per every 305 m
(1.8°F per every 1000 ft) above sea level to a
maximum of 3050 m (10,000 ft), no direct
sustained sunlight. Maximum rate of change is
10°C/hr (18°F/hr). The upper limit may be
limited by the type and number of options
installed. System performance may be reduced if
operating with a fan fault or above 30°C (86°F).
-30° to 60°C (-22° to 140°F), maximum rate of
change is 20°C/hr (36°F/hr).
10 to 90% relative humidity (Rh), 28°C (82.4°F)
maximum wet bulb temperature, non-
condensing.
10 to 95% relative humidity (Rh), 38.7°C
(101.7°F) maximum wet bulb temperature, non-
condensing.
3050 m (10,000 ft). This value may be limited by
the type and number of options installed.
Maximum allowable altitude change rate is 457
m/min (1500 ft/min).
9144 m (30,000 ft). Maximum allowable
altitude change rate is 457 m/min (1500 ft/min).
Page 36