Unpacking - Sharp AL-1215 Service Manual

4. Unpacking

Be sure to hold the handles on both sides of the copier to unpack the
copier and carry it to the installation location.
5. Removing protective packing materials
1) Remove pieces of tape and protective cover. Then open the origi-
nal cover and remove protective materials (a) and (b).
AL-1215/AL-1530CS
AL-1540CS/AL-1551CS
2) Release the scan head locking switch.
Grasp here and turn in
the direction of the arrow.
Lock Unlock
AL-1215/AL-1530CS
(AL-1551CS only)
AL-1551CS
AL-1540CS
AL-1540CS/AL-1551CS
AL-1551CS UNPACKING AND INSTALLATION 5 - 2
6. Installing the TD cartridge
The TD cartridge replacement required (
when toner is needed. If copying is continued while the
lit, copies will gradually become lighter until the copier stops and the
indicator begins blinking. Replace the old TD cartridge by following the
procedure given below.
Note:
• After the copier stops, it may be possible to make a few more copies
by taking the TD cartridge out of the copier, shaking it horizontally,
then reinstalling it. If copying is not possible after this operation,
replace the TD cartridge.
• During long copy run of a dark original, the ready (
blink, the indicator may light up, and the copier may stop, even
though toner cartridge is not empty. The copier will feed toner up to 2
minutes and then the ready (
print ( ) key to restart copying.
1) Ensure that the bypass tray is open and then open the side cover
by pressing the open button on the side cover.
2) Remove the CAUTION tape from the front cover and remove the
two protective pins from the fusing unit by pulling the strings
upward one at a time.
CAUTION tape
3) Push gently on both sides of the front cover to open the cover.
4) Remove the TD cartridge from the bag. Remove the protective
paper. Hold the cartridge on both sides and shake it horizontally
four or five times.
4 or 5 times
) indicator will light up
indicator is
) indicator may
) indicator will light up. Press the
Protective pins