Table of Contents
Advertisement
[5] UNPACKING AND
INSTALLATION
1. Unpaking procedure
Be sure to hold the handles on both sides of the copier by two
persons to unpack the copier and carry it to the installation location.
2. Installing procedure
1) Remove all pieces of tape. Then open the original cover and
remove the protective material.
2) Use a coin (or suitable object) to remove the screw.
•
Store the screw in the paper tray because it will be used if the
copier has to be moved. (Refer to the description in the follow-
ing.)
3) Ensure that the bypass tray is open. Raise the side coverrelease
handle and pull out the side cover until it stops.
4) Push gently on both sides of the front cover to open the cover.
5) Gently pull the TD cartridge out while holding the handle.
6) Hold the strap on the cartridge and remove the TD cartridge up-
ward.
7) Remove the new TD cartridge from the bag. Hold the cartridge on
both sides and shake it horizontally four or five times.
8) Hold the tab of the protective cover and pull the tab towards you
to remove the cover.
9) Gently insert the TD cartridge along the guides until it locks in
place.
•
If dirt or dust is adhered to the TD cartridge, remove it before
installing the cartridge.
10) Close the front cover by holding both sides with your hands and
then close the side cover. The TD cartridge replacement re-
quired indicator will go out and the START key indicator will light
up.
•
When closing the covers, be sure to close the front cover
securely and then close the side cover. If the covers are
closed in the wrong order, the covers may be damaged.
5 – 1
AL-1610
TD cartridge handle
4 or 5 times
Advertisement
Chapters
Table of Contents
